Hi,

I am trying to retrofit my GLK with the UCI system. However, after i hook up the main MOST connector, I can't start the car and i get all these error messages in the speedo display like:

ESC non-functioning
Airbag malfunction
traction control malfunction

Any Ideas where i may have gone wrong? Thanks

-KP

Sounds like a disconnected cable. Only a diagnostic system can tell you what is loose.

Check the fuses.

__________________
www.benzmodz.com .... putting the Me into Mercedes.

Where did you connect power, ground, and wakeup to for the UCI interface ?

Have you read my retrofit document on Mercedes Electronics upgrades, installation and retrofits ?

Richard

__________________
Of course i'll take it apart.

www.mercupgrades.com
www.comandonline.co.uk

Either the cockpit harness is not happy or there is a disconnect/fuse in the front SAM.

__________________
www.benzmodz.com .... putting the Me into Mercedes.