Thread: SLnks.350 Canbus

Hi,
Need to connect front parking senors to canbus connection, usubig a CanM8 & need to find the Can Hi & Low wires....Any ides to save me time?

Tha

Which canbus are you looking for ? B, C or D

Where do you intend to localise the module ?

Looking briefly at the CANM8 device ( CANM8-RPM CAN Bus RPM Signal Interface from CANM8 )

It looks to me like it will go in the interior can bus

Look in the passenger footwell wiring duct (under carpet on outside edge of the footwell) - theres a device about 8cm x 1cm with lots of CAN connections (all with brown,brown/red twisted pairs going into it). If its not there, look above the passenger footwell kick panel below the glovebox

Cheers

Richard

If it is going in the rear then he will probably need a feed out of the rear SAM. I would buy a W203 left-side to right-side CAN-B cable (not used in 2005+) and cut that to length. That makes it easy to terminate the connector into the SAM and then join to the existing module.

He can probably get power from the same connector that parktronic normally uses.